UPSC PYQPrelims 2013

Civil Services Examination · Question 88

Ball bearings are used in bicycles, cars, etc., because

  1. the actual area of contact between the wheel and axle is increased

  2. the effective area of contact between the wheel and axle is increased

  3. the effective area of contact between the wheel and axle is reduced

  4. None of the above statements is correct

Show answer & explanationShow explanation

Answer: (C) the effective area of contact between the wheel and axle is reduced

Explanation

Concept: Ball bearings replace sliding friction between a rotating wheel hub and a shaft/axle with rolling friction using spherical steel balls. Contact Geometry: Without ball bearings, the cylindrical axle slides directly against the sleeve of the wheel over a large surface area, causing high frictional drag and heat. When spherical balls are placed between the inner and outer races, contact occurs only at tiny points on each sphere. Effect on Effective Contact Area: Thus, the effective area of contact (and surface deformation/interlocking) between the wheel and axle is greatly reduced, lowering friction by an order of magnitude (μ_rolling ≪ μ_sliding). Result: Ball bearings are used because the effective area of contact between the wheel and axle is reduced. Related Facts: • Order of Friction Magnitude: Static friction > Sliding (Kinetic) friction > Rolling friction. • Roller Bearings: Use cylindrical or tapered rollers (line contact instead of point contact) when much heavier radial loads must be supported. Correct Answer: (c) the effective area of contact between the wheel and axle is reduced

Diagram explaining the answer